How to install tile floors is a question that is too often asked by DIY enthusiasts. While it is true that tile floor installation is not rocket science, it is also true that this kind of installation requires some level of skill, knowledge, and most importantly patience. A perfectly clean and precise tile floor installation is certainly not that difficult. With proper planning, necessary pre-installation prep, and following our step-by-step installation guide, you should be able to wrap up your installation project in no time! Can you seal tile and grout at the same time?
- Surface Preparation: Ensure that the surface on which you will do the installation is clean, smooth, and dry. If there are any damaged or uneven areas level those out.
- Mark the center: Take a measurement tape, measure the room in one direction and mark the center. Repeat the measurement in the other direction and mark the center. Take a marker and draw a line across the center points. The point where the two lines intersect each other will be the center of the room.
- Start the layout: Do a dry run. Layout the tiles from the center in both directions. Use tile spacers as and when necessary. Feel free to reposition the starting point if needed. Once you are satisfied with your layout, put a mark around the center tile.
- Final installation: Get started with your installation by placing the center tile. Apply adhesive. Use adhesive as instructed by your tile manufacturer. Take a trowel and using the flat side, spread a quarter coat of adhesive on the surface of one grid area. Next, hold the trowel at a 45-degree angle and apply adhesive ridges. Place the tile on the center point. Move it back and forth to make it sits properly in its place.
- Install the rest: Use the center tile as the reference and install the other tiles along a straight line. Use tile spacers in between to create the grout lines. Cut tiles to size it for the end rows, if needed. Do not use too much adhesive as it’ll ooze up when pressing the tiles.
- Allow adhesive to dry: Once you are done with the installation, leave it overnight.
- Mixing grout: Once the adhesive dries, mix the grout. Its consistency should be like peanut butter. Grout is available in different colors. You can choose the right one to match your tiles. Take some mixture and use a rubber grout float to fill the joints. Repeat it throughout the area.
- Cleaning up your tiles: Once you’re done with grouting the joints, wipe it off with a soft, damp cloth or a sponge. Make sure you don’t pull up grout from the joints. The grout manufacturer will give you instructions on how to cure the grout.
So, that’s all about tile floor installation. Do you think that’s difficult? Not really, isn’t it!
How much does it cost?
While DIY tile floor installation is relatively inexpensive. Depending upon the tile texture, size, shape, and color the cost may range anywhere from $1 to $15 per sq ft. Owing to variation in prices, most people opt-in for the readily available sets of durable glazed ceramic tiles that cost around $2 to $4 per square foot. tile installation cost per square foot
However, if you are thinking of pro installation then that will certainly shoot up your cost per sq ft to install tile flooring. Depending upon the amount of pre-installation prep needed the average cost for a pro installation may range anywhere from $7 to $14 per square foot. Again, any kind of complex patterns or decorative pieces will boost up your cost, both for materials and labor.
